| Powerforum http://www.powerforum.dk/ |
|
| fra lav ohm til høj ohm http://www.powerforum.dk/viewtopic.php?f=7&t=16729 |
Side 1 af 1 |
| Forfatter: | Mark [ 14 sep 2006, 22:29 ] |
| Titel: | fra lav ohm til høj ohm |
Hvad skal man tjekke i Megatune ved sådan et dyse skift ? software version 24s13c |
|
| Forfatter: | Mark [ 19 sep 2006, 09:49 ] |
| Titel: | |
upp..... hvordan skal de PWM settings stå ? ved højohms dyser |
|
| Forfatter: | Saab-Daniel [ 19 sep 2006, 10:26 ] |
| Titel: | |
Her er snippet lidt fra vejledningen på www.megasquirt.info On the Settings/Constants page: If you are running high-impedance injectors (greater than 10 Ohms), then set the: PWM Time Threshold to 25.4 msec, and the PWM Current Limit (%) to 100%. If you have low impedance injectors (less than 4 Ohms), set the: PWM Time Threshold to 1.0 msec, and PWM Current Limit to 75%(30% if you have installed the 'Flyback Board' daughter card). You will tune these after getting the engine running. See “Setting the PWM Criteria” in this section. Failure to perform these steps can result in damage to your injectors. If you have high-impedance injectors, set these values to 25.4 ms and 100%, and you do not need to tune them further. Søg mere info her: http://www.megamanual.com/v22manual/mtune.htm Daniel. |
|
| Side 1 af 1 | Alle tider er UTC + 1 time |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|